General Turning Inserts VCGT Carbide Inserts
|
Length |
Size(mm) |
|||
|
IC |
S |
d |
r |
|
|
11 |
6.35 |
3.18 |
2.81 |
0.1-0.4 |
Product Information
VCGT Turning Inserts.V -quadrilateral shape of turning insert - rhombic (35°)
C - Insert with clearance under main cutting edge (7°)
G - Tolerances and dimensions of carbide turning insert
T- Hole through insert and single sided chip-breaker
VCGT turning insert with very positive flank, positive rake angle and sharp cutting edge for optimum cutting performance. Sharp cutting edge for optimum cutting performance.Carbide construction for strength and rigidity. Heat and wear resistant properties for prolonged tool life.Cutting edges reliability, precision with a smooth surface.Corrosion resistance high brightness
Specifications
|
Application |
Type |
Ap (mm) |
Fn (mm/rev) |
Grade |
|||||||||||
|
CVD |
PVD |
||||||||||||||
|
VK4215 |
VK4315 |
VK4225 |
VK4325 |
VK4235 |
VK4335 |
VK1005 |
VK1035 |
VK1328 |
VK1505 |
VR1525 |
VR1010 |
||||
|
Small Parts Machining |
VCGT110301- FS |
0.1- 1.5 |
0.02- 0.06 |
• |
O |
O |
|||||||||
|
VCGT110302- FS |
0.2- 2.0 |
0.05- 0.12 |
• |
O |
O |
||||||||||
|
VCGT110304- FS |
0.2- 2.5 |
0.08- 0.25 |
• |
O |
O |
||||||||||
• : Recommended Grade
O: Optional Grade
Application
The type of carbide grade and the coating on inserts is originally intended for turning aluminum, non ferrous (aluminum alloy, copper, wood, glass fiber, carbon fiber reinforced plastic and other nonferrous metals and alloys)
FAQ
1.What is a machining insert?
A wiper insert is an insert used in a milling machine or a lathe. It is designed for finished cutting, to give a smooth surface on the surface being cut. It uses special geometry to give a good finish on the work-piece at a higher-than-normal federate.
2.What is successful face milling?
Face milling is the most common milling operation, and can be performed using a wide range of different tools. Cutters with a 45º entering angle are most frequently used, but round insert cutters, square shoulder cutters, and side and face mills are also used for certain conditions. Be sure to choose the right cutter for the operation, for optimal productivity (see information on choice of tools below).
3.What is successful high-feed milling?
When machining aluminum, and sometimes when machining cast iron with CBN or ceramic inserts, cutting speeds of more than 1,000 m/min can be used, which result in a very high table feed, vf. This type of machining is called High-Speed Machining (HSM).
In milling short-chipping materials, such as gray cast iron, a face milling cutter with an extra-close pitch can be used, resulting in high table feed. In HRSA materials where cutting speed is normally low, an extra-close pitch results in a high table feed.
4.Do you offer samples?
Yes, we do offer samples. However, buyers need to pay for the freight charge. In addition, whether samples are free or not depends on the quantity you buy.
Hot Tags: cemented carbide inserts, China, suppliers, factory, buy, price, cheap, quotation, free sample
